A sump pump is typically a specialized appliance designed for pumping water out of a basement or crawl space, especially in areas where flooding is possible. Frequently, homeowners are most familiar with sump pumps as a preventative measure for preventing basement floods in case of extreme weather, high water levels in low-lying zones, or other legitimate reasons. Sump pumps are typically required to be installed by a building owner when the property is built. If you’re interested in having your sump pump installed, we’ve written the following article to give you the low down on sump pump installation.
As mentioned above, sump pumps are typically required to be installed by a building owner when the property is constructed. If you’re wondering when the required installation should occur – according to the rules of the US National Fire Protection Association (NFPA), the installation of sump pumps should be performed “as soon as practical.” The NFPA states that it’s important to install the device “as quickly as reasonably possible” once foundation footings and walls have been installed. They also recommend the installation of the units “as close to the floor level as is feasible.”
There are many reasons why a basement may need to be flooded in order to ensure the safety of family members. Acts of God such as hurricanes, tornadoes, strong storms, and flooding can all wreak havoc on property owners. It’s often best to install sump pumps as soon as possible, especially if the property is located near a body of water. The American Society of Home Inspectors recommends the installation of the device “as quickly as practical.” Regardless of when you should install sump pumps, the actual installation process is not overly difficult, provided certain guidelines are followed.
In order to properly install sump pumps, it’s important that the proper conditions exist for the device to function properly. The primary factors that contribute to the proper functioning of this type of equipment include the presence of adequate outside access points, a properly drained sewer or drainage system, a high enough floor level, and a proper level of surrounding foliage and soil. Following these simple steps will help you prevent flooding from occurring.
Outside access points are necessary for sump pumps to properly discharge excess water into the crawl space. In older properties, this will likely be located in a gutter system. Today, most sump pumps use a float switch to allow access to the area. If the float switch is damaged or disabled, however, it is possible to access the water drain via a hole in the floor.
In older properties, the location of the sump pumps may not be accurately determined. A pressure sensor or an electronic timer may be used in order to determine the correct water level. Both of these items are monitored by sump pumps. If either device malfunctions, the pump must be reseted. For this reason, many new pumps incorporate both a pressure sensor and an electronic timer.
Low levels of ground water can result in mold and mildew buildup if not addressed quickly. The presence of mold or mildew can create breathing difficulties and significantly damage the structural integrity of your home. While sump pumps can help resolve the problem, in some cases mold and mildew buildup may occur regardless. Mold remediation can be costly and time-consuming. To protect your family, it is important to address any mold issues as soon as possible.
Proper sump pump installation will protect your family from the potential dangers of mold and mildew. Remember to consult with your contractor about the potential dangers of electrical power and water in your home. Additionally, if you have any questions about the installation of your sump pump, don’t hesitate to contact your chosen company for a consultation. Your trusted plumber can offer the knowledge and experience necessary to ensure your sump pump installation is completed safely and properly. Your family’s health and safety are simply too important to neglect your plumbing system.